Laser Master 2 stops at the same point every single time

I keep getting the following error. The workstation isn’t moving, USB is secure, not going to sleep. happens at the same spot every single time.


Reset while in motion. Grbl cannot guarantee position. Lost steps are likely. Re-homing is highly recommended.

On or near line 16999:

Job halted

Stream completed in 17:16


Ortur Laser Master 2 Ready!

OLF 137.

Grbl 1.1f [’$’ for help]

[MSG:’$H’|’$X’ to unlock]

[MSG:Caution: Unlocked]


Alarm:3 is usually a limit switch trip.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.