Laser min power stuck at 10% can't change it

[Stroonzo (Jeff)]

Layer "Power Min" with GRBL

GRBL doesn’t have this level of control - it’s either constant power for the whole cut, or ramped based on speed. DSP controllers, like Ruida, allow setting both a low and high (min/max) power for the ramp, but GRBL has no method for this. Increasing your acceleration can help with this, and on a normal Line layer there’s an ‘overcut’ option that will got just a little farther around closed shapes, and that would help here too. The $31 parameter works backwards to what you think it does - it …