Laser not engraving correctly

[parsec (FerAS)]

Run the job in the following link:

Burn Offset LighutBurn 1.7.03

Given one picture and four words, I think @JimNM has nailed it. This test pattern helps identify mechanical problems: GrundTest.lbrn2 Scale it to fit the platform and run it as fast as it will go in Line mode with optimizations turned off and power set to mark a sheet of cardboard. Any differences from the design will be informative. Upload good photos of the result so we can look over your shoulder.

If the output is different from what shows in the Preview follow the below guide:

Guide to mechanical adjustments and maintenance

If you have more issues write back.