Laser not firing with uccnc

[Rick (Technical Evangelist)]

GCODE output finetuning to UCCNC

While I was searching for how to generate gcode what the UCCNC can digest, I found this topic " Stepcraft 840V2 and UCCNC controller UC100 " what helped me a lot. I would still have 3 problems. 1, after M3, I need an M10 Q255 command to switch the laser on. I made a replace all while post processed the gcode, from M3 to M10 Q50 and it worked. M5 switched off. The best would be, if I would have M3 only at the beginning and M10 Qxx would switch it on, M11 would switch off. 2, at the “header”, …

Lightburn with UCCNC

We’re planning to make a generic GCode output device - it is planned, but we prioritize supporting existing users and fixing any reported bugs over pretty much everything else, so time estimates are subject to change.