Hello everyone, I have had a 50 watt VOIERN 40mm/60mm laser for two years now and I have never had a problem until now, when I try to engrave an image the laser stops working in some areas.
I have a RUIDA controller.
could someone guide me please
Hello everyone, I have had a 50 watt VOIERN 40mm/60mm laser for two years now and I have never had a problem until now, when I try to engrave an image the laser stops working in some areas.
I have a RUIDA controller.
could someone guide me please
it appears that the alignment is off. the laser beam must pass thru all three mirrors and hit the lens at all four corners of the bed. I would clean and check/align the mirrors.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.