Laser paused during a Fill and burned a hole

[Stroonzo (Jeff)]

The first and maybe easiest step in your case would be to SHIFT+Send for execution (rather than clicking start).

Start vs Send on Wifi

“Send” just sends the file to the laser. “Start” sends it as a temporary (unnamed) file, and the laser begins running the job when “enough” data has arrived. (I’m not sure what counts as “enough” in this case - it’s up to the hardware). If you are sending a job that has photo engraving, or high-speed engraving, those can take a decent amount of CPU horsepower to execute the job, and receiving the file also requires CPU time. If the job is complex enough, it’s possible for the controller to s…