Laser pointer Turned on

[Flyer (Gregorio Barroso)]

How can I see the cutting or engraving area with the laser pointer turned on? my machine is with a 20w diode laser. Grbl 1.1 f. Cheers

[LightBurn (Oz)]

How do I turn on my diode at low power to focus it or frame a job?

Diode lasers often don’t have a red-dot pointer like CO2 lasers do, so it is often useful to enable them at low power for focusing or framing. (Please do NOT do this if you have a CO2 laser, as the beam is invisible and this could blind you or start a fire) In LightBurn, go to Edit > Device Settings, or click here: [image] Turn on the ‘Enable Laser Fire Button’ switch (make it green): [image] Quit LightBurn and re-run it. You will now have two new controls in the Move window. A …

[Flyer (Gregorio Barroso)]

I have enabled the laser fire button. This works perfect for focusing the laser. But if I give the function to see engraving area the laser turns off. Is there a setting to keep the laser shot on while checking the engraving area?

[LightBurn (Oz)]

Did you read to the end?

[Flyer (Gregorio Barroso)]

Ok perfect.