My Otrur Laser Master Pro 2 starts a project and then the laser shuts off in the middle of the project but the machine still goes through the motions but no laser. I have downloaded the newest version of Lightburn , I have cleaned the machine with compresed air, I have unplugged and repluged the machine into the power sourse and still the problem is there. This is a new problem. I have had it plugged into the same power source before and haven’t run into this problem.
Is the fan still running on the laser when it cuts off?
Sounds like an old firmware issue
In console type $i
Press enter
Copy/paste here the full output that comes in console after that command