I upgraded to a 5.5 laser from my 2.5, my question how do I get it to work at its full capacity on lightburn, do I need to change any settings? Please advise.
Should be no changes required at all - the controller just specifies a percentage of the maximum power to use, so if you run with the same settings you used in the past, you should be getting double the power output.
Do I gm have to change the $32 code on the software or leave it as it was which was 255
$32 should never be 255 - it should be 0 or 1 (spindle mode or laser mode)
$30 might be 255, or 1000, and the number is mostly irrelevant as long as it’s 255 or higher.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.