Hello every body
I just recived my new x carve, with a opti 6W laser on . It goes home without any problems and it reacts upside down and to the sides, but when I want to two laser engraving from zero on the x and y, the laser head moves to the right and start engrave 40-50 cm avay?
But why? Anyone how Can help me?
Most likely you haven’t set up the workspace offset needed to run the machine in positive workspace coordinates, instead of negative. Read here: https://github.com/LightBurnSoftware/Documentation/blob/master/CommonGrblSetups.md#other-machines
In addition, you’ll need to set:
$10=0 (report position in workspace coordinates)
$32=1 (laser mode on)
thanks for the help, that was exactly what was wrong 