My machine is a creality cv 01 pro laser engraver. Basically i turn on the machine, it beeps, homes and stays there. If i were to open say LaserGRBL it would work just fine. But if i open lightburn, the machine re-homes when the software connects to it, and as soon as it homes to X:0 Y:0 the progres…

lightburn issues - if you set it up that way - a Home command on connection Edit → device settings [image] however is strange that it makes the machine freeze it should not happen at all Uncheck to see if you can gain control of lightburn Then click Home button. Stuck too? Could you share yo…

Launching lightburn jams the laser engraver

LightBurn Hardware Compatibility

gilaraujo (Gil Araújo) April 17, 2024, 9:50pm 8

try this thread

EDIT! might be a dif machine
CV30 vs CV1?