I just updated to 1.1.00 and noticed a bug right away. I have updated two of my PCs and confirmed this bug on both. I even downgraded one to 1.0.06 as a sanity check. Previously, when drawing a line, the shift key would work to make the line horizontal or vertical. This has apparently been broke…

I have created a screen recording of the exact same operation in both 1.0.06 and 1.1.00: 1.0.06: LB 1 0 06 - YouTube 1.1.10: LB 1 1 00 - YouTube

I am using a regular mouse, I don’t have access to test with a track pad at the moment, will try later this afternoon

Apologies, I have tested again and you are correct. Will try on 1.0.06 just to make sure

Have now tried on version 1.0.06 and can confirm this behaviour.

That’s good to know that I’m not just going crazy over here… It’s always good to know others are able to recreate an issue.

I can reproduce the bug on W11 touchpad.

Same issue here. Here’s a quick workaround until a fix is released. Hold shift, draw line, continue to hold shift, hit escape, release escape and left click mouse. Seems to be working so far for me. Using the tool normally seems to place the line wherever your cursor is whether you hold shift or not…

no problem here, works as in 1.0.06

Thank you for bringing this to our attention. I can also reproduce this behavior and have generated a report for our dev team to investigate further. :slight_smile:

I think what’s happening is that the object and grid snaps are taking precedence over the horizontal / vertical snap. Working on this now. We’re likely going to be doing a small patch release in the next day or two, so I’ll try to get this fixed up for that.

LightBurn Software Forum

LB 1.1.00 Drawing tool Bug Report

LightBurn Software Questions

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled