I could not get LB to work with my iMac (see closed issue, I had to make this new one). So I went and bought a PC and it is running on a Ryzen7, 16GB RAM with Windows 11. The EXDACT same thing is happening again on PC, it connected yesterday to my Snapmaker 2 using the Snapmaker device and today it …

Take a look at the remedies listed here. Try each of these and see if this resolves the issue. [image] AtomStack A5 Pro/MacBook Pro have to reinstall laser every time LightBurn Software Questions 4 potential remedies: Do you have this issue if you turn on the laser befo…

Tried all the suggestions, no dice. But I did notice something, when I select the GRBL instead of Snapmaker it does connect but of course the SN2 does not recognize the commands being sent. Example, echo:Unknown command: “��M��M��M��M��M��M�M��M��M��M��M��M…

I’m not familiar with Snapmaker but found this Topic that steps through the installation. I think the main item will be setting DTR on in Device Settings. [image] Snapmaker 2.0 A350 Setup Guide Snapmaker Hi all, As suggested by @jlropes here is rough guide which I hope w…

I often have to manually select the com port in the bottom row of the Laser window (middle of row) [manually select com port and snapmaker] I’m pretty sure your Snapmaker 2 should use Snapmaker. I believe it’s a custom version of Marlin. Snapmaker seems to also need a CH340 driver - https://sn…

LB stopped working, again!

LightBurn Software Questions

berainlb (PY) February 11, 2022, 4:37pm 4

I’m not familiar with Snapmaker but found this Topic that steps through the installation. I think the main item will be setting DTR on in Device Settings.