LightBurn Software Forum

Light burn wont recognize my snapmaker 2 A 350. All hooked up

LightBurn Hardware Compatibility Snapmaker

Rick (Technical Evangelist) February 16, 2021, 9:27pm 2

Snapmaker 2.0 A350 Setup Guide Snapmaker

Hi all, As suggested by @jlropes here is rough guide which I hope will help other users to get their Snapmaker 2.0’s working with Lightburn Software. First steps with a freshly powered on SM2 is to use the calibration method in the controller taking into account the material thickness and the automated focusing and that sets a focus height that’s referenced in machine Z co-ordinate. Then set working co-ordinates X&Y to suit and that then refers to your bottom left reference in Lightburn. By d…

Snapmaker: where creation happens – 19 Oct 20

Lightburn Device Flavor - "Snapmaker", not "Marlin"

Snapmaker 2.0

EDIT: There’s a much easier way to do what I was trying to do, and that would be properly configure Lightburn, ha. Leaving the post up for posterity with the newer instructions A new Lightburn device needs to be created using the Snapmaker...

Reading time: 3 mins 🕑 Likes: 26 ❤

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled