Lightburn and Gcode Setup

[parsec (FerAS)]

Congratulations and welcome.
Read the following thread:

Saving GRBL GCode Settings for importation in UCCNC

Good day to all fellow laser users, sorry for the lengthy post. I have been tackling a particular problem for a long while without any success in finding a solution even though I searched everywhere from this forum to YouTube. Basic outline: my 130W laser is servo driven, using UCCNC software & hardware, so connecting directly to the machine is out of the question up to the recent Lightburn software 1.6.00. So I am transfering jobs by saving the GCode in Lightburn, using GRBL-M3 (the only one t…

And see if the Custom GCode device check all your marks.