Dear Loren Thank you for your advice,
Seems like this is an issue with your design since it is pretty consistent. Attach a copy of your file.
Alignement Issue.lbrn2 (149.8 KB)
The font is Google font, generally downloadable on Google site. I convert them to path, and weld them,
The font still looks like a complete line.
One thing to check is the tension on your belts. With the power off tilt the machine up in the front and the Y carriage should slide slowly from front to back and not bang into the top of the machine. Tilt the machine up on the left and the X carriage should slide slowly across the X axis and not bang into the side of the machine. If it doesn’t do this the belts may be too tight.
Yes, it does as you describe when I lift up one side around 30 degrees, both in X and Y direction, so I assume the tension is OK.
Is your machine set to absolute position and the laser rotary is turned off. Does your machine home ok when you turn it on.
It comes back to home position when turned on, Yes.
I use Absolute position, yes.
Try doing a test of just a circle and see what it looks like.
I found out that I cannot even make a simple circle, drawn on LightBURN