LightBurn Calibration Says Rotary is Enabled When It Is Not

When I went to engrave the registration marks, a dialog box popped up asking if I wanted to disable the rotary. When I went to check it later, I could see the rotary was already disabled. Has anyone else seen this behavior?

It’s a bug in the check that was introduced in 0.9.16. It’s fixed already for the next release.

Thanks Oz! Just wanted to be sure it wasn’t on my end. Not sure if you saw my other post, but I am having an issue with Steps Per Rotation not having any impact on engraving and I thought maybe I had another issue was going on.

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.