Pops31024
October 23, 2020, 4:55pm
1
3018 pro with 5.5w laser. Burns just fine in lasergrbl but will burn anything in lightburn.
Rick
October 23, 2020, 5:34pm
2
Is this an update or are you asking a question? This post will return you very little as you have not provided nearly enough information for anyone to offer back reasonable responses to help you.
Folks,
When asking for support for LightBurn via this forum, email or anywhere else, please keep the following tips in mind for the fastest and most helpful answers.
Please provide these details:
We need to know what machine you have, what controller it has, and what firmware it is running.
Are you running the latest version of LightBurn?
Is the issue new, or has it happened before? What kind of computer is it, and what Operating System is it running?
Please note these things:
Please speak…
You can also use the search at the top of every forum page to help find subjects that may have been covered already.
Read here about configuring your 3018, the speed/power issue, and more:
The summary:
Turn on Laser Mode to get rid of the travel lines
You’re trying to move too fast, which is why you don’t get enough power
You need to zero the machine
3018’s are pre-configured for use as CNC machines, not lasers, so their settings and speeds will likely need to be changed to give you acceptable results with LightBurn.
To see the existing settings, you can type $$ into the console in LightBurn and press enter, or go to Edit > Machine Settings. Both are showing the same values, b…
1 Like
system
November 22, 2020, 5:34pm
3
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.