Lightburn starts in wrong place

[MikeyH (Mike Hembrey)]

@Jks0157

Frame works fine but then when I actually run program it ‘shifts’ to different location and starts.

That is the same as runs okay but frame is in wrong place. This dialog might be worth reading…

Error:20 Unsupported or invalid g-code

Hi guys. New controller with grbl (MKS DLC32) and I am new to grbl. I have read all the posts in the forum regarding this error, but have not been able to solve it. I tried to do a test by trying to carve a first test script. I disabled the Z axis (even though it is actually there on my machine) but it still doesn’t work. Starting stream Layer INCISIONE error:20 Unsupported or invalid g-code command found in block. On or near line 4: Job halted Stream completed in 0:00 ok First line of gco…