If I cut several passes, lightburn stopps at 99% if job is ready.
The laser returns correct in end position, but I have to click “stopp” to end the job in lightburn, too.
Laser is a NEJE Master 2S Pro.
The same to me using Ortur LM2 Pro S2.
I just purchased the Ortur LM3 and am having the same issue.
I’m also having issues where it looses connection during jobs.
Did you ever figure out a solution other than disconnecting and reconnecting it each time?
i have the same issue afer installing 1.3.01. atomstack pro7. I’ve been fiddling with it to no avail.
This may be due to the controllers for these GCode lasers being ESP32 based - please try going to ‘Edit > Device settings > Enable DTR signal’ and let us know if it solves your issue.
I know its an older topic - but with more ESP32’s out there - want it to be known selecting Enable DTR fixed the problem for me.