Lightburn stops at a wrong pass number or with missing layers

Hi there,
I’m really wired because I’m almost not able to finish any job.
No errors in the console. As you can see in the following picture, it was expected to make 21 passes. But after 2 passes the job stopped with a “Stream completed” message.

errore

Same situation could happen at layer change. So definitely jobs are aborted without error messages.

Do you have any advice? I really don’t know what to check without hints. The machine is a Snapmaker 2.0 with Marlin firmware.

Thanks. Gianluca

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.