Lightburn will only engrave on passthrough mode

[Payola5000 (Paola Estrada Warn)]

I imported a PNG image into lightburn, but it will not run unless it’s on passthrough mode. In other modes it generates faulty Gcode and never gets past the 0:01 run time. Here is what appears on the console every time:

Starting stream

G00 G17 G40 G21 G54

G90

G4 P1

M4

M9

G0 X22.833Y87.863

Layer engrave

G91

G1 X2.083F8000S281.1

G1 X1.122S278.7

G1 X1.763S281.1

G1 X0.32S278.7

G1 X1.443S281.1

G1 X0.32S278.7

G1 X1.763S281.1

G1 X1.442S283.5:285.8

G1 X1.282S288.2:285.8:283.5:283.5

G1 X0.481S281.1:278.7:278.7

error:1

G-code words consist of a letter and a value. Letter was not found.

On or near line 14:

error:1

G-code words consist of a letter and a value. Letter was not found.

On or near line 14:

error:1

G-code words consist of a letter and a value. Letter was not found.

On or near line 14:

Job halted

Stream completed in 0:01

This didn’t happen to me before the update of 1.3.00. I’m using an Atomstack X7 on Windows 10
Apa con B.lbrn2 (2.9 MB)

[berainlb (PY)]

Can you save gcode for an example burn using a .txt extension and upload here?

[Payola5000 (Paola Estrada Warn)]

https://drive.google.com/file/d/1_v9lvl0tWwBLl8BlX0OOEMm5iyx7Q_9R/view?usp=sharing

File is too big, but here’s a link to it

[Payola5000 (Paola Estrada Warn)]

I found the issue: gcode clustering was on, I turned it off and it started working like a charm again