Lines connecting when running

[Jbke (Jurgen Brugghemans)]

After thé update when it burn something i get conection lines between seperate parts

Cant find thé solution to get them away.
Any ideas

[LightBurn (Oz)]

Check this please:

Laser not turning off between cuts? (burning during travel moves)

If you have a GRBL device, and your laser is still on when moving between shapes, like this: [image] It most likely means you are using GRBL 1.1f or later, but do not have the controller in Laser Mode. Fix this by typing $32=1 in the Console window and pressing enter If you have a Ruida or other DSP controller and are seeing this happen, it is most likely a dying high-voltage power supply unit (PSU). The drive circuit that turns the laser power off and on tends to go first, before the part …

[Wrenchforhire (John)]

I have the same problem, and after reading the FAQ’s I have checked and reset $32=1 with no change.