Linux mint + lightburn + sculpfun cam500 = failure

[Babitruc (MarcBonin)]

I use the Sculpfun CAM500 camera on a Linux min Virginia (v21.3).
I use the latest version of LightBurn.
My camera is detected by the Linux system and I can use it without problems with the Cheese application.
In LithBurn, the camera is listed in the camera list, but when I select it. I have no preview and I can’t do the following to calibrate it.
I’m running out of ideas to find a solution.

I’m French and my English is very approximate. Thanks to the online translators.

Translated with DeepL.com (free version)

[gilaraujo (Gil Araújo)]

Hello Marc,

Are you using the AppImage or the Manual install method?

[Babitruc (MarcBonin)]

It’s a good question. I forgot this. I believe it was via AppImage.
Thanks

[Babitruc (MarcBonin)]

I haven’t used apt-get or apt-install. If it helps.

[Babitruc (MarcBonin)]

After checking, I installed via the .run executable file and launched the installation via bash ./file.run