Liscense problems

I have 2 lasers, 50w co2 and a ortor diode, however Lightburn will not allow me to run 2 lasers, Help needed. Thank You

Why? What is telling you this, and what does it say exactly? Which controllers are used to drive these lasers?

If you purchased a GCode version, you may need the DSP version if your CO2 laser use Ruida, TopWisdom or Trocen motion control systems. If this is the case, you can purchase the upgrade here: LightBurn Software - Upgrade from GCode to DSP license

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.