Hey guys, i have a problem with my new 80w red and black laser. Ruida Control. When i do fill on lightburn that on the photos happen, a litle jiggle or small lines on the edges, but only on big things. Any thought?
I tried low speeds, it helped but i Will loose time and it stays the same.
Tried higher acc speeds, still the same.
No overscan option on Ruida.
Im using lightburn at 150mms normaly.
Thanks guys 
and sorry for my bad English.
Check the ‘advanced’ panel on your fill layer for offset adjust
Hey there, thanks for the Help. I Will try that and update.
Still the same, it reversed. Now happen on small things and not on big things. I found a topic with the same problem, but not understand the solution.
Line shift?
We are in-process, rewriting our documentation, so please excuse the dust, but this is worth review: Scanning Offset Adjustment - LightBurn Software Documentation
Hey guys, thanks for the Help. But the problem dont go away. !
If it is only one square its ok, but if i do 5 squares, the middle ones are bad and the sides ok.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.
