I have an issue wirh my Lightburn software. When i about start my engraving i get a messages saying sonething to the effect "machine is busy how do i fix that?
I see that you’re commenting in a CO2 laser thread but your profile has TwoTrees listed as your device type.
I’m going to move this into the TwoTrees section so we can get other sets of eyes on this concern.
We’re going to need a lot more information to understand what’s going on. If you followed set-up instructions from LightBurn or TwoTrees it would be great if you could link those here.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.