Marlin profile fully work but engraving the Traversal moves


After upgrading the tronxy x5sa-400 with neje laser module, I bought the licence for the lightburn to start using the laser engraving and cutting,
After a long time of finding out how to see it up, I’m stuck in having this issue, it is engraving the Traversal moves, keep in mind the firmware has laser mode enabled, power of laser firing is controllable (by setting the power of the cut and buy changing the firing power in the move widow).
I’m not being able to make any engraving or cutting correctly.

Please advise


This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.