Is there a way to have a bit more control over the material test?
Pity because the user control over this software is first class, compared with all other cnc software I have used…
…except for this glaring error.
Hi Simon,
What exactly would you like to control a bit more?
1 Like
- Its very confusing to get it exactly where you want it on the bed. It defaults to the middle, so you have to estimate where you put the material or waste some.
- You can only have 2 variables on each test. The third variable is tucked away in a difficult to find location. Why? WHy cant you have three variables in a single test? Its not that hard to figure out.
- Why cant the test be shown graphically on the workspace, just like any other job?
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.