Hi guys, New here. Just fired up my Master 2 pro S2 and tried to run a material test. I’m getting no ‘writing’ and only a few squares are being marked out by the laser. Am I missing something?
Perhaps it’s running in mm/sec, rather than mm/min, which would (try to) send the head zipping around 60× faster than the laser can handle.
1 Like
You’re in the right speed zone!
However, a maximum speed of 18 k mm/min is probably too high.
These guidelines may help:
And away you go!
Happy cutting …
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.