Hi,
I had min power setting for each layer until I upgraded LightBurn to 1.1. It’s disappered.
(I am using GRBL 1.1h)
As I understand it, the minimum power for GRBL has only ever been effective for Grayscale image engraving. If you load an image that setting should appear on the cuts/layers palette as before.
Thanks for the reply.
As I know the min power takes effect also on acceleration and decceleration, and on corners. In this situations the min power helps to prevent overburning, but maybe it’s a mistake and effective only on grayscale images.
Here is an old post from Oz.
LightBurnOzOwner / Lead Developer
You can do it when using grayscale mode, and it behaves exactly as you say. Line mode and the different dither modes are just on/off though, so there is no min power used. With DSP controllers, the Min Power setting on lines controls the lowest power the machine uses during a cutting move, when cornering. GCode devices do not have the ability for me to set this.
Oh, okay. Thank you very much, then this was my mistake.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.