Hello, our laser seems to be misshaping and skipping certain bits in line mode. I don’t think it’s a mechanical issue as the laser will make a mistake on one letter then go on to do 3 perfect ones. The previews and image are fine onscreen but the result is off.
Any help would be appreciated. Thanks
I suspect that’s a comms error. Maybe a bit of interference in the cable between the computer and the laser?
You reckon replacing the cable might help? Ta, I’ll give that a crack.
Top man, that’s sorted it. Thanks very much for your help
All good mate. Happy to help.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.
