I just used MobaXterm to set up a USB camera stream for my Sovol SV07 3D printer. It’s pretty cool. I plugged the USB cam into the “brick” (control module) of the SV07 and used MobaXterm to connect to it using the machine’s IP address.
I’m not THAT tech savvy (I could read the instructions), but I wondered if it might be possible to plug a USB camera into the USB port of my OMTECH (red-and-black-Chinese) laser cutter, and accomplish the same thing with the Lightburn camera tool setup, Ruida controller, etc.
If that were possible . . . whoa! . . . way cool!