Moving Omni X in Z Direction and Autofocus

LightBurn Software Questions
1

Hi I own a commarker Omni X 6W and currently using the 2.1 RC1.
As far as I saw ther weill be a feature now for moving also in Z Direction but In the commarker you have to Trigger Up and down through Pin 3,4 as far as I saw. Can you add this as well because I only see a Motor 1,2 interace right now which will not fit.
Also the possibility to trigger Auto Focus would be really helpful because for this I alsways have to switch to commarker studio.

Thanks
Patrick

2 Likes
2

I’d especially like the autofocus feature brought to lightburn.

1 Like
3

You and I both. We’re aware of it (we have 3 Omni’s in house) and will add it as soon as we can.

1 Like
4

Thanks that would help a lot

5

I actually just autofocus in the commarker software, then close it and open LightBurn.

But yes, it’s on our list.

6

I use commarker for the 3d embossing because you can also lower the focus during the operation and of course for the inner glass engraving. I hope this feature comes also soon in lightburn.

1 Like