Hello,
I Just installed the newest Software ( 0.9.02) and can jog the Z-axis with the software.
Before i Had 0.8.5 i think but didnt Test moving z with Software.
But it IS also not working. It follows the shape x-times, but without moving the bed.
Number of passes : 3
Z step per Pass 3.00 mm
Z-axis enabled in settings
Relative Z moves only ist disabled (also not working when enabled)
I tried Focus Z and without Focus. When its focused i can only lower the bed (away from Laser), but not into the Laser.
Software Version is 0.9.02
Thanks for any Ideas to solve this.
Best regards
Cedric