My cut line is offset to the left if my engraving

LightBurn Hardware Compatibility Ruida controllers
21

Any suggestions, Oz?

22

What is the idle acceleration?

23

Here’s pictures of my machine settings

PXL_20210927_223213535
PXL_20210927_2232135351512×2688 771 KB
PXL_20210927_223220455
PXL_20210927_2232204551512×2688 751 KB
PXL_20210927_223227261
PXL_20210927_2232272611512×2688 724 KB
PXL_20210927_223235648.MP
PXL_20210927_223235648.MP1512×2688 753 KB
PXL_20210927_223241723
PXL_20210927_2232417231512×2688 727 KB
PXL_20210927_223248121
PXL_20210927_2232481211512×2688 740 KB
PXL_20210927_223259416
PXL_20210927_2232594161512×2688 757 KB
PXL_20210927_223304952
PXL_20210927_2233049521512×2688 723 KB
PXL_20210927_223321313
PXL_20210927_2233213131512×2688 742 KB
PXL_20210927_223326244
PXL_20210927_2233262441512×2688 743 KB

24

Your ‘PWM rising edge valid’ setting is enabled for X, and not Y. Try turning it off on the X axis too - as long as both axis are using the same type of motor driver, those should be set the same, and this is a really common error with the machine builders.

2 Likes
25

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.