My designs are engraved or cut in reverse


Could someone give me a hint that I might have modified wrongly in LightBurn? :thinking:

Until a few days ago I used to put the designs in the program and send them to engraving or cutting without any problem, but these last days I have to send the designs inverted (mirror) so that they are engraved correctly and not inverted.

I don’t remember touching anything in the program, but I’m sure it’s something I’ve modified without realizing it.

Any ideas? :hugs:

Thanks for your contributions.

Somehow, your machine origin got changed. You can correct it in Edit/Device Settings. Should be set to the corner that your machine homes to upon powering it up.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.