My laser get to 65% of the job and stops

Hi everyone,

I have tried to figure this out for 2 days but no luck. I am quite new to using a laser. I used the lase without problems last time. Yesterday I started using it again and it gets to 65% of the job and stops. It gives me ALARM: 3 Reset while in motion. Grbl cannot guarantee position. And when I type $$ in the console I get this code: HLP:$$ $+ $# $S $L $G $I $N $x=val $Nx=line $J=line $SLP $C $X $H $F $E=err - ! ? ctrl-x.
I have an ACMER P1 S PRO and I am using the last version of LightBurn
Can someone help please, I need the laser to fulfill my orders!
Thank you

Are you running out on the y axis or x axis???

Hi, Thank you for replying. I am not sure. I had this machine for only a couple of weeks and used a handfull of times. How do I check?

I have attached a couple of screenshots, does it help to answer your questions?

I have also attached 2 screenshots of the message I get every time I try to engrave something, and what I get in the console after it stops.




Is the laser head as far to the left as it can travel when it halts? Then it is hitting the limits of the x-axis.
Maybe take a photo of the laser when it gives you this error?

Try moving project away from edges and try.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.