Hello,
So my laser Neje 3 Max started to engrave slow after an firmware update. I have updated everything to the latest version (Neje Software and Lightburn) but it still engraves slow. Something that is shown to be ready in less than 5 minutes is actually ready in more than 10. I tried to change the speed, but the higher the speed, the slower the engraving is. What should I do?
This is the info from the controller:
$I
[VER:1.1f.NEJE build version:v2.0.0:]
[OPT:VMZHL,199,1000]
Target buffer size found
ok
Laser temp:25.9C
$$
$0=10
$1=255
$2=0
$3=0
$4=0
$5=0
$6=0
$10=3
$11=0.010
$12=0.002
$13=0
$20=0
$21=0
$22=1
$23=1
$24=250.000
$25=2500.000
$26=250
$27=1.000
$30=1000
$31=0
$32=1
$40=0.200
$41=10
$42=10
$43=0
$100=80.000
$101=80.000
$102=800.000
$103=8.889
$110=15000.000
$111=15000.000
$112=1200.000
$113=21600.000
$120=250.000
$121=250.000
$122=20.000
$123=250.000
$130=810.000
$131=460.000
$132=45.000
$133=360.000
ok
Thank you!