My Lightburn framing and my Ruida framing do not match

[Rick (Technical Evangelist)]

@pgonzalez

Do you have any idea what that might be about?

You have not provided enough for us to supply you with a definitive answer. I could guess, maybe the speed of this job is set below the threshold set in the controller.

Ruida / LightBurn won't cut below 10mm/s

This isn’t a LightBurn issue, but a Ruida one that’s quite common. There’s a controller setting called “Start Speed” that defaults to 10mm/sec. At that speed, power starts ramping up from Min Power to Max Power. Cutting at or below that speed means you’re using Min Power only, so if you’re cutting slow, set both Min and Max power the same and you’ll have no issues.

Only a guess.