I have a NEJE Master 2S Max and I use Lightburn software but i experienced a really weird problem today which i never had before when cutting text, the laser was cutting a line between letters (see picture 1), so i tried to tune some settings then this happened (see picture 2), when i try to cut anything my machine just starts doing non-sense and following a weird path.
I tried with text and shapes but same problem, i think i might messed with the wrong settings, i tried restarting the machine, reinstalling the software but still haven’t managed to get it to work properly.
I hope someone could help me here, thank you guys.
Picture 1 is typically caused by the laser not being configured for laser mode ($32=1).
Picture 2 is indicative of a license validation issue, typically from using an improperly licensed version of LightBurn. Where did you get the key? If from the official LightBurn site then I suggest you email support@lightburnsoftware.com with your details and they will help sort you out. If you did not purchase a key then get one at LightBurn Software - GCode License Key and retry. You will need to cleanup your current installation and reinstall from the official download there. You may have a problem with installation due to fragments left over from the previous installation but post again in that case. I’d also suggest a thorough malware scan on your computer as they’re often bundled with illegitimate copies.