My SFX 50W JPT is showing as "Disconnected"

Breaking in my SFX 50W JPT fiber laser and after having initial success installing the laser, EZCad 2 and then some engraving success with Lightburn…I now am unable to connect to Lightburn.

I had noticed that I never calibrated the lens and therefore needed to correct the lens distortion and bulge effects, so I chose to do that through EZCad 2. Once I adjusted the specs, I tried to reconnect through Lightburn but with no avail.

Right-clicking just hangs, artwork doesn’t frame or fire, rebooting does nothing positive, etc.

At this point, I can use EZCad 2, but I’d prefer Lightburn.

Thoughts?

Disregard.

Just ran Zadig again and like magic…all good.

1 Like

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.