New controller,

LightBurn Software Questions
,
1

I have a Chinese laser 6565

I had to replace the controller New one is (Lunyee = 2 Axes controller, USB GRBL control board for laser graving machines)

I am using lightburn version 2.1.02

I am on new Dell computer (my son set it up when my other lost harddrive I usually use a mac)

I have had my laser for over 3 years, and have used LightBurn for that time. Pretty much a novice, I have a wood shop and burn mostly wood projects.

When I replaced the controller I set up a new device all settings work fine, but when I did my first graphic it did it upside down, Iā€™m sure it is a setting in lightburn have tried a few things with no luck. Any Ideas?

2

This is likely a Machine Origin mismatch: