It seems both the LightBurn and the LaserWeb4 prefer the GRBL firmware driven controllers. I will have to look into the Anet A8 controller and see if it can be reloaded with a GRBL type firmware.
The Prusa seems to move with the LaserWeb4 but thats about it thus far until I get into the software. The Prusa is fixed a 115200 I think. Too bad the LightBurn can’t be configured for other com rates.
There is a growing market out there for converting an inexpensive 3D printer to a laser engraver. Too bad these software programs don’t work easily with them.
If anyone has additional insight into what I am attempting I would appreciate your input.
Thanks,
Rob