New k40 installation

Now my laser installation is nearing completion. A couple of points remain, the largest to have a hole drilled in the brick wall. I have the laser machine in the garage and forced ventilation is needed regardless.

I went through my “to do” list and no less than 45 points are ticked, with 5 left.

  • Drill hole in the wall
  • Print wall valve
  • Electric drawing
  • Seal K40 lid
  • Water chiller

Here are a couple of pictures, I have done smaller test shots, but no real work yet.


Nice install!

Thanks! Im not quite sure about how to use the z-axis yet, but I’m sure I will figure it out while going.

Internal panel for calibration and max current output.