New to Lightburn and Laser

[berainlb (PY)]

@lwjones1956

I did this originally and Lightburn did not recognize the file type to import xTool_D1.lbdev Tried again just now and I still can’t import the file as the directions say

Where are you doing this? The .lbdev file is a native LightBurn file.

You need to push the Devices button in Laser window, then push Import, then pick the file.

Else take a look at this post. It shows all the defaults for D1 that you can copy.

Laser burns outside framed target

Your device settings are not “standard” for the D1. You have 2 options. Either create a new device by loading that file I linked earlier. Or you can change all your settings until it matches these exactly. Basic Settings Tab: [image] Gcode tab: [image] This should resolve the issue you’re having with the crosshairs not lining up to framing. Hold off on entering Console commands as I don’t think that’s the problem. I’ll document it here for future reference. Copy-paste one command at a …

@lwjones1956

changed the grid spacing and something else and now it prints right side up

This would have been the Origin setting. It needs to be at top-left for D1.