I just installed lightburn on ubuntu 18 lts.
Laser on Genmitsu (3018) aka sainsmart unit.
The software cannot connect to usb and just repeatedly responds with
“waiting for connection” as I cycle through ports. I have had it connected
with UGsender and it recognized the port.
I don’t know. I will research this.
Is there a way to run the LightBurn app via sudo?
Do you know how to give that app permission?
Unfortunately I am going to have to take a hiatus from this as my grbl board
burned out and I had to send away for a new one. A power chip exploded and the angry
electron pixies escaped.