I am trying to engrave a logo in lightburn but as a new laser user it a bit of a new learning curve, I mainly use a 3d printer so bear with me, I can burn the logo ok but some areas ie. top and bottom are very dark and not very good, can I have some advice on the logo I have enclosed for any ideas how to improve, My laser is a neje master 2s 20w, sorry about the picture as its not very clear but I used my webcam for this.
Maybe if they were bunny rabbits it wouldn’t be so dark…
Sorry, I couldn’t help myself…
If you separate the dark portions of the logo into a new layer, then you can independently adjust the intensity. The difference in shading comes from the significant differences in image density.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.