I just got an XTool S1 (10W, maybe the last one :grinning_face: ) I was able to connect and burn something with the XTool Studio. Now I’m trying to get it to work with the latest LightBurn (2.1.04) (I’m new to both S1 and Lightburn.)( So looking at various posts here, there’s an old (2024) discu…

Please review this thread: [image] Setting up xTool S1 with new xTool device type in LB 1.7 and Beyond xTool This device type does not support the xTool F1 or P2. It does not support ANY network device at this time You can download LightBurn from here: Downlo…

Thanks! There seem to be a few minor differences between that description and the current LB version, but nothing that stopped me from burning something. The offset on my device seems to be Y 4.6mm, BUT I’m not sure if I located and measured that correctly. That’s the difference between where a b…

You can set the correct Pointer Offset: [image] Laser Offset Setup for Red Dot Pointers - LightBurn User Guide Learn to fine tune the position of your red framing laser to accurately frame designs in LightBurn.

New XTool S1, latest Lightburn, I'm confused

LightBurn Hardware Compatibility

parsec (FerAS) September 9, 2026, 6:53pm 2

Please review this thread: