Newbie, not too clear where to go

[Rick (Technical Evangelist)]

@Pureamericana

Also, how do I go about setting up a scale for the various modes, pwr and settings etc?

PLEASE NOTE: This the following post presents a file that was created for an 80w CO2 laser. Adjust the settings for your system before running!

Material Cut/Scan Test Files - Power Scale

UPDATE LightBurn now has a very powerful material testing tool built right in! Find it in the top bar menu under ‘Laser Tools > Material Test Generator’ Please check out our documentation for a full run down on all the features: Material Test - LightBurn Software Documentation [image] If you’re here specifically looking for the manual material test files and instructions, click the arrow below.

Expand this section to see manual material test files

Here is a test file created using the ‘Arra…

Using a similar concept for image mode testing, you could replace the “squares” grid with a grid of a control image to achieve this.